Thinget XC Series - 4-1. List of Basic Instructions

Basic SFC Functions
4-1. List of Basic Instructions
XC1, XC3, XC5 series basic SFC instructions
Mnemonic Function Format and Device
LD
(LoaD)
Initial logical operation contact
type NO (normally open)
X, Y, M, S, T, C, Dn.m, FDn.m
LDI
(LoaD Inverse)
Initial logical operation contact
type NC (normally closed)
X, Y, M, S, T, C, Dn.m, FDn.m
LDP
(LoaD Pulse)
Initial logical operation-Rising
edge pulse
X, Y, M, S, T, C, Dn.m, FDn.m
LDF
(LoaD Falling Pulse)
Initial logical operation-Falling
/trailing edge pulse
X, Y, M, S, T, C, Dn.m, FDn.m
AND
(AND)
Serial connection of NO
(normally open) contacts
X, Y, M, S, T, C, Dn.m, FDn.m
ANI
(AND Inverse)
Serial connection of NC
(normally closed) contacts
X, Y, M, S, T, C, Dn.m, FDn.m
ANDP
(AND Pulse)
Serial connection of rising edge
pulse
X, Y, M, S, T, C, Dn.m, FDn.m
ANDF
(AND Falling pulse)
Serial connection of
falling/trailing edge pulse
X, Y, M, S, T, C, Dn.m, FDn.m
OR
(OR)
Parallel connection of NO
(normally open) contacts
X, Y, M, S, T, C, Dn.m, FDn.m
ORI
(OR Inverse)
Parallel connection of NC
(normally closed) contacts
X, Y, M, S, T, C, Dn.m, FDn.m
ORP
(OR Pulse)
Parallel connection of rising edge
pulse
X, Y, M, S, T, C, Dn.m, FDn.m
ORF
(OR Falling pulse)
Parallel connection of
falling/trailing edge pulse
X, Y, M, S, T, C, Dn.m, FDn.m
ANB
(ANd Block)
Serial connection of multiply
parallel circuits
None
ORB
(OR Block)
Parallel connection of multiply
parallel circuits
None
OUT
(OUT)
Final logic operation type coil
drive
Y, M, S, T, C, Dn.m
SET
(SET)
Set a bit device permanently ON Y, M, S, T, C, Dn.m
RST
(ReSeT)
Reset a bit device permanently
OFF
Y, M, S, T, C, Dn.m
PLS
(PuLSe)
Rising edge pulse X, Y, M, S, T, C, Dn.m
PLF
(PuLse Falling)
Falling/trailing edge pulse X, Y, M, S, T, C, Dn.m
47