2-38
2
DRIVE MOTOR 2.12
23 Apply light grease to both the outer and inner face
seals. Install the face seals on the balance ring(fig.
C275).
Assembly cont’d.
25 Align the case drain hole in the valve housing with
the matching hole in the valve plate. Install the valve
housing on the valve plate (fig. C277)
24 Insert your finger through the port of the valve hous-
ing (fig. C276). Apply pressure to the side of the balance
ring to hold it in place while the valve housing is being
installed.
IMPOTRTANT
C275
C277
C278
The face seal must be installed as shown in figure
C275 or the motor will not op0perate properly.
C276
IMPORTANT
After installing the valve housing, check between the
body parts for unseated seals.
26 Install the four bolts fingertight in the valve hous-
ing(fig. C278). Torque the bolts in the sequence shown
to 50 ft/lbs. (67.8 nm)
To Next Page
Loading...
