Toa A-9120DHM2 - Page 62

62
(A24) Pre-paging tone ON/OFF setting (when the ZP-001T is used)
P R E P A G I N G - O F F
(A25) Operation mode setting (when the ZP-001T is used)
M O D E => P A G I N G P O R T
(A26) Priority setting (when the ZP-001T is used)
P R I O R I T Y 2
Set priority level of the sound source set to the paging input.
Note
Changing the parameter in this item during paging broadcast interrupts all paging calls being mode through
any channel.
(A27) Paging duration time setting
P A G I N G T I M E 3 0
Sets the paging duration time.
This setting prevents broadcasts from unintentional continuation due to erroneous operation in telephone
paging made using the ZP-001T module.
(A23) Output assignment and level settings
(when the D-001T/R is not used and the paging is set to OFF)
I N 1 - > O U T 1 0
Set which output channel in what level an audio source at the currently selected input channel should be
output to.
Select the output channel from Channel 1 to 8 (maximum) with the Left or Right shift key, and set the output
level with the Parameter setting knob. By repeating this procedure, output level can be assigned to 2 or more
output channels.
Pressing the output channel ON/OFF key alternately switches the level between "0 dB" and "– ∞."
OUT1 – 2, Max. 8 when T-001Ts are used (default: OUT1)
0 dB (default)
–∞, –70.0 dB to +10.0 dB, 1 dB steps
Setting Range
Output Channel
Assigned Output Level
Set whether or not to sound a one-tone chime before paging.
When set to OFF, the tone does not sound at the paging telephone, either.
ON, OFF (default)
Setting Range
Select the method of activating paging.
• PAGING PORT: Paging is operated if a start signal (no-voltage make signal) is received from the paging
port when the connection between the unit and PABX is established.
• RING SIGNAL: Paging is operated if an IR signal is received when the connection between the unit and
PABX is established. The ZP-001T module functions as a telephone.
PAGING PORT (default), RING SIGNAL
Setting Range
1, 2 (default), 3Setting Range
30 sec, 10 min
Setting Range