MINTER Configuration
P/N 7010-0681
2-21
• Data recording auto-start on page 2-24
Figure 2-17. Receiver Configuration – MINTER Tab
Recording Interval parameter
This parameter specifies the message output interval into the log
file when the MINTER FN key (pressed for 1–5 seconds)
activates data logging. This setting is used for both logging a
single log file, and logging receiver data in AFRM mode. Values
are 1–86400 seconds.
The default value is one second.
Elevation Mask for Log File parameter
This parameter specifies the minimum elevation angle for the
satellites whose data will be put in the receiver files logged when
pressing FN.
The default value is five degrees.
File Name Prefix parameter
This parameter specifies the prefix added to the names of receiver
files created when pressing FN. The prefix can be up to 20
characters long.
The default value for the Name Prefix is “log”.
Log file names have the following structure:
<prefix><month><day><sequential alphabet letter>
To Next Page
Loading...
