Topcon HiPer Pro - Page 57

MINTER Configuration
P/N 7010-0681
2-25
Also, if Always is enabled, your receiver will automatically start
logging data (to a newly created or an existing file) in the
following three cases:
• After turning on the receiver using the Power key.
• After resetting the receiver (using PC-CDU or pressing the
Reset key).
• After taking the receiver out of Sleep Mode.
3
File specified;
receiver data
logging not
started.
No file will open
with this name.
Data logging will
not start when
power is restored.
No file will open
with this name.
Data logging will
not start when
power is restored.
A log file with this
name will open and
data logging will
start after power is
restored.
4
No file
specified;
receiver data
logging off.
Data logging will
not start when
power is restored.
Data logging will
not start when
power is restored.
A log file with a
default name will
open and data
logging will start
after power is
restored.
Table 2-2. Data Recording Parameter Behavior (Continued)
Before
Power
Failure
Enabled Radio Button Results
Off On Always