Topcon HiPer Pro - Page 67

Bluetooth Module Configuration
P/N 7010-0681
2-35
6. Enter up to 14 characters to set a unique name for the Bluetooth
module (Figure 2-26), and click Apply.
Figure 2-26. BTCONF Parameters Tab
7. To set security parameters (Figure 2-27 on page 2-36), enter and
enable the following, then click Apply:
• Bluetooth PIN – enter up to 16 characters to specify a
personal identification number for the Bluetooth module.
• Encryption – enable to have the Bluetooth module encrypt
wirelessly sent data. To read encrypted data, the user must
have the same PIN used in the device that sent the data.
• Authentication – enable to require a PIN before two
Bluetooth enabled devices (such as, the receiver and a
computer) can establish a communication link. The two
devices must use the same PIN.
NOTICE
NOTICE
If you do not need security settings, leave these
parameters disabled.