Toptech MultiLoad II - Sampleralarm Messages

Chapter 7 – Register Operations
15
7
Read/Write Register=2598, Len=1, 16-Bit Integer (ppppp)
Read/Write Register=2599, Len=1, 16-Bit Integer (rrrrr)
Read/Write Register=cannot be accessed, Len=1, 16-Bit Integer (ttttt)
Read/Write Register=cannot be accessed, Len=1, 16-Bit Integer (mmmmmmmmm)
Read/Write Register=cannot be accessed, Len=1, 16-Bit Integer (nnnnn)
7.2.39 716 - SAMPLERALARM MESSAGES
R716iii => 0?0716iiilllllsssssssssssssssssssssssssssssscccccppppprrrrrttttt
U716iiilllllssssssssssssssssssssssssssssss => 0?0
U716iiilllllsssssssssssssssssssssssssssssscccccppppprrrrr => 0?0
U716iiilllllsssssssssssssssssssssssssssssscccccppppprrrrrttttt => 0?0
U716iiilllllsssssssssssssssssssssssssssssscccccppppprrrrrtttttmmmmmmmmmnnnnn
=> 0?0
Where:
iii = Alarm Index with defaults as:
struct alarm_def factory_sampler_alarm[16] =
{
{"*SAMP FCM" , AUTO_CLEAR}, // 716000
{"*SAMP PERM", AUTO_CLEAR}, // 716001
};
Note: For Modbus, not available.
lll = Alarm Level as:
enum
{
AUTO_CLEAR = 0,
DRIVER_CLEAR = 1,
REMOTE_CLEAR = 2,
PROGRAM_CLEAR = 3,
WM_CLEAR = 4
}alarm_level;
ssssssssssssssssssssssssssssss = Alarm Message (prefix with an *)
Note: Up to 30 UTF-8 bytes to represent a max of 10 characters.
ccccc = Promotion Count (00000=no promotion)
ppppp = Promoted Alarm Level as:
enum
{
AUTO_CLEAR = 0,
DRIVER_CLEAR = 1,
REMOTE_CLEAR = 2,
PROGRAM_CLEAR = 3,
WM_CLEAR = 4
}promoted_alarm_level;
rrrrr = Reset Mode as: