Toptech MultiLoad II - Remote Transaction Data

Chapter 6 – Meter Commands
76
unsigned char unused15:1;
unsigned char unused16:1;
unsigned char unused17:1;
unsigned char unused18:1;
unsigned char unused19:1;
unsigned char unused20:1;
unsigned char unused21:1;
unsigned char unused22:1;
unsigned char unused23:1;
unsigned char unused24:1;
unsigned char unused25:1;
unsigned char unused26:1;
unsigned char unused27:1;
unsigned char unused28:1;
unsigned char unused29:1;
unsigned char unused30:1;
unsigned char unused31:1;
} flags;
} tank_alarms;
Modbus:
Not supported.
6.21 REMOTE TRANSACTION DATA:
MRTDpppaaa
This command is used to get the batch data out of the Multiload2.
Where:
/* request transaction details for preset RTDpppaa */
/* where RTD = Request Transaction Detail */
/* ppp = preset number */
/* aaa = detail index */
/* */
/* if aaa = 000 reply RTDpppaaannn */
/* where RTD = Request Transaction Detail */
/* ppp = preset number */
/* aaa = detail index request (=000) */
/* nnn = number of details */
/* */
/* if aaa > 000 reply RTDpppaaa... */
/* where RTD = Request Transaction Detail */
/* ppp = preset number */
/* aaa = detail index request (>000) */
/* ... = detail values (same as R800) */
/* */
Modbus: