Toptech MultiLoad II - Page 37

Chapter 6 – Meter Commands
37
per meter(5):
ddddddddd = meter delivered gross quantity in whole units
Note: if the Use Hundredths W&M RCU parameter is enabled, the gross quantity value will have an implied two decimal places.
Ddddd = meter gross flow rate in whole units
Modbus :
Where: p = preset (0-11), m = meter (0-4)
Read Only Register=4192+p*5+m, Len=2, 32-Bit Integer (ddddddddd (gross))
Read Only Register=4312+p*5+m, Len=1, 16-Bit Integer (ddddd (rate))