Toro Greensmaster TriFlex 3400 - All of the Cutting Reel Motors Are Identical; Check for Proper Bedknife Adjustment and the Overall Condition of the Reel. Adjust the Bedknife if It Is out of Alignment; Connect 48 V Power to the Cutting Units. Refer to; Cutting Reel Motors

g225145
Figure25
1.Cuttingunit1(center),whichincludesreelmotor13.Cuttingunit3(right),whichincludesreelmotor3
2.Cuttingunit2(left),whichincludesreelmotor2
4.Checkthecuttingunitandthereelmotorforanymechanicalresistance,andmakesurethatthereelsare
freeofanyforeigndebris.Removeanydebristhatisfound.
5.Checkforproperbedknifeadjustmentandtheoverallconditionofthereel.Adjustthebedknifeifitis
outofalignment.RefertotheapplicableCuttingUnitOperator’sManuallistedinExternalReference
Material(page8).
6.Connect48Vpowertothecuttingunits.RefertoConnectingandDisconnectingthe48VPowertothe
CuttingReelMotors(page18).
7.Operatethemachine.
Pass
Thefaultdidnotrepeat.GotoReturningtheMachinetoService(page21)andfollowthestepslisted.
Fail
Thefaultrepeated.GotoStep3.
Step3:Swapcuttingreelmotorsbetweencuttingunits.
Allofthecuttingreelmotorsareidentical.
1.Verifythat48Vpowerhasbeendisconnectedfromthecuttingunits.RefertoConnectingand
Disconnectingthe48VPowertotheCuttingReelMotors(page18).
2.Swapcuttingreelmotor2withacuttingreelmotorfromadifferentcuttingunit.RefertotheGreensmaster
TriFlex3320/3420ServiceManual,Chapter6,ServiceandRepairssection,CuttingReelMotor.
3.Connectthe48Vpowertothecuttingreelmotors.RefertoConnectingandDisconnectingthe48VPower
totheCuttingReelMotors(page18).
4.Operatethemachine.
48