Toro Reelmaster 5100-D - Loss of Traction Power or Unit will Not Operate in Either Direction; No Cutting Units Operate

_________________________________________________________________________________________
___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ______ ___ ______ ___
___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ______ ___ ______ ___
___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ______ ___ ______ ___
___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ______ ___ ______ ___
___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ______ ___ ______ ___
_________________________________________________________________________________________
___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ______ ___ ______ ___
___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ___ ______ ______ ___ ______ ___
__
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ _______ __ __ __ ____
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ _______ __ __ __ ____
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ _______ __ __ __ ____
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ _______ __ __ __ ____
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ _______ __ __ __ ____
__
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ _______ __ __ __ ____
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ _______ __ __ __ ____
Loss of Traction Power or Unit Will Not Operate In Either Direction
Cause Correction
Engine RPM too l
ow. Adjust, use tachometer.
Drive shaft disconnected or damaged. Repair or replace drive shaft.
Traction control linka
ge damaged or disconnected. Repair linkage.
Transmission reservoir oil level too low. Fill to proper level.
Charge pressure too low. Inspect for plugged transmission filter and replace if
necessary.
Inspect charge relief valve and clean or replace if
faulty.
Inspect charge pump and repair or replace if faulty.
Traction pressure too low. If pressure is low in only one direction (forward or re-
verse) check affected system relief valve and repair
or replace if faulty.
Repair or replace transmission (pump &
motor).
No Cutting Units Operate
Cause Correction
Improper
operation of lower-mow/raise control lever. Hold lever in forward (lower-mow) position until front
cutting units begin operating. Do not allow lever to
“slap” back to neutral.
Electrical problem. See Chapter 5 - Electrical System.
Damaged pump or pump coupl
er. Repair coupler and pump if necessary. NOTE: Steer-
ing and cutting unit lift will also be affected.
Reelmaster
®
5100-D Page 4 - 17 Troubleshooting