Toro Reelmaster 5100-D - Chapter 7 - Steering and Brakes; Special Tools

__________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
Specifications
Item Specification
Front wheel lug nut torque 45 to 55 ft-lb
Front to rear housing torque 18 to 28 ft-lb
Transmission to axle torque 25 to 30 ft-lb
Differential bearing caps torque 30 to 45 ft-lb
Ring gear to differential case torque 45 to 65 ft-lb
Fill pipe torque 20 to 30 ft-lb
Side plate (gear cover) torque 25 to 40 in-lb
Axle shaft bearing retainer (nut) torque
With hex head screw 37 to 45 ft-lb
With socket head screw (newer models) 16 to 20 ft-lb
Ring gear to pinion gear backlash 0.003 to 0.007 in.
Pinion gear end play 0.00 to 0.005 in.
Special Tools
NOTE: Order special tools from the TORO SPECIAL Catalog for your Toro equipment. Some tools may also
TOOLS AND APPLICATIONS GUIDE (COMMERCIAL be available from a local supplier.
PRODUCTS)
. Some tools may be listed in the Parts
Differential Gear Holder
Remove gear cover from right hand side of differential
and bolt this tool in place to lock spur gear in position
when removing nut that secures pinion coupler for 4WD
drive shaft.
Figure 2
Special Tools Page 6 - 2 Rev. A Reelmaster
®
5100-D