Crankshaft
1. Perform steps 1 - 5 under Piston and Connecting Rod
in this section.
2. Remove the flywheel.
3. Remove the rear oil seal case.
4. Remove the main b
earing caps (Fig. 91). Keep each
set of bearings together with its bearing cap.
5. Remove the crankshaft.
6. Inspect the removed parts. Repair or replace any
worn or damaged parts (Fig. 92).
Figure 91
Figure 92
Reelmaster
®
223-D/5100-D Page 3 - 63 Cylinder Block Overhaul
To Next Page
Loading...
