_________________________________________________________________________________________
_____________ ________________ ______ ________________ ______ ________________ __________________________________ ______________________________
_____________ ________________ ______ ________________ ______ ________________ __________________________________ ______________________________
__
__ __ __ __ __ __ ___
__ __ __ __ __ __ ___
General Run and Transport Problems
Condition Possible Cause Correction
Engine continues t
o run, but Engine fuel lever or run solenoid Check operat
ion of run solenoid
should not, when ignition key is stuck in “on” position. and adjust or replace if necessary.
turned off.
Make sure fuel stop lever moves
without sticking and repair if
necessary.
Ignition switch faulty. Replace ignition switch.
Engine continues t
o run, but Seat switch circuit is closed. Check seat plate hinges and seat
s
hould not, when traction pedal is support pin and repai
r if faulty.
engaged with no operator on seat. Check for water soaked seat
cushion.
Test seat switch and replace if
faulty.
Check seat switch wiring and
repair if faulty.
Traction neutral switch circuit Check traction neutral switch
closed. adjustment and adjust if faulty.
Test traction neutral switch and
replace if faulty.
Check traction neutral switch
wiring and repair if faulty.
Engine kills during operat
ion, but Seat lifting off seat switch. Instruct operator to sit back in
restar
ts. seat during operation. Operate
m
achine slower when operating
in rough terrain.
Seat switch circuit open. Check seat plate hinges and seat
support pin and repair if faulty.
Test seat switch and replace if
faulty.
Check seat switch wiring and
repair if faulty.
Faulty ignition switch. Replace switch.
Faulty ignition switch wiring. Repair wiring.
Reelmaster
®
5100-D Page 5 - 11 Troubleshooting