Toro Reelmaster 5100-D - Cutting Units Raise too Fast or too Slow; Cutting Units Raise, but will Not Stay up

_________________________________________________________________________________________
_____________ ________________ ______ ________________ ______ ________________ __________________________________ ______________________________
_________________________________________________________________________________________
__
__ __ __ __ __ __ ___
__
Cutting Units Raise, But Will Not Stay Up
Cause Correction
S6 energized (should only be energized during Do electrical diagnostics. See Chapter 5 - Electrical
l
ower function). System.
S6 leaking down (not seating proper
ly). Do cartridge valve service procedure for valve S6.
Replace S6 with a new valve if faulty.
Cutting Units Raise Too Fast or Too Slow
Cause Correction
One-way variable orifice not properly adjusted (cen- Adjust variable orifice for affected circuit.
ter and rear
cutting units only) - see Hydraulic Sche-
matics.
Reelmaster
®
5100-D Page 4 - 23 Troubleshooting