Installing the Engine
1. To install the engine, perform steps 2 - 17 of Removing
the Engine in reverse order.
2. Install a new engine oil filter. Fill engine with the
correct oil. Fill the cooling system with a 50/50 solution
of ethylene glycol antifreeze and clean, soft water.
Check for oil and coolant leaks and repair as necessary.
3. Adjust throttle linkage (See Throttle Linkage Adju
st-
ment in the Adjustments section of this chapter).
Reelmaster
®
223-D/5100-D Page 3 - 45 Removing and Installing the Engine
To Next Page
Loading...
