Glow Relay
To test the glow relay (Fig. 17), disconnect the relay wire
connector and install a continuity tester between the
relay terminals (terminals 30 and 87) (Fig. 19). The relay
should make and break continuity at terminals 30 and
87 as 12 V.D.C. is connected and disconnected to
terminal 85 with terminal 86 connected to ground.
85
86
30
87
RED/WHITE
ORANGE
RED
Figure 19
Battery
1. Use a volt-ohm meter to measure the voltage be-
tween the battery terminals.
2. If the voltage is less than 12.3 Volts D.C. , the battery
should be charged.
NOTE: Regulated voltage will increase to 13.5 Volts
when the engine is running.
Figure 20
Reelmaster
®
5100-D Page 5 - 23 Testing
To Next Page
Loading...
