Toro Reelmaster 5100-D - Front Roller Adjustment

Front Roller Adjustment
Loosen four (4) capscrews holding front roller brackets.
Push roller towards the rear, then hold in position and
tighten capscrews. Make sure roller has not changed
position. NOTE: When securing front roller brackets,
tighten fastener on inside of cutting unit frame so posi-
tion of roller bracket does not change.
1
Figure 10
1. Roller bracket
Set Up and Adjustments Page 8 - 10
Rev. A
Reelmaster
®
223-D/5100-D/5300-D