Toro Reelmaster 5100-D - Timing Gears and Camshafts

Timing Gears and Camshafts
1. Remove the cylinder head (see Cylinder Head Re-
moval in the Cylinder Head Overhaul section of this
chapter).
2. Remove the gear case (see Gear Case and
Oil Pump
in this section).
3. Remove the snap ring and remove the idle gear
(Fig. 77).
4. To remove the injection pump camshaft:
A. Remove the governor weight assembly (Fig. 33).
B. Remove camshaft rear cover.
Figure 77
C. Remove the stopper bolt (Fig. 78).
D. Pull out t
he camshaft from the front of the cylinder
block.
5. To remove the valve camshaft:
A. Pull the push rods and tappets out of the cylinder
block.
B. Remove the camshaft stopper bolt.
C. Pull the camshaft out of the cylinder block
(Fig 79).
Figure 78
Figure 79
Cylinder Block Overhaul Page 3 - 56 Reelmaster
®
223-D/5100-D