8. Check the governor parts for wear or damage
(Fig 74). Replace parts as necessary.
A. Remove the expansion plug (Fig 75). Be careful
to not scratch the gear case.
B. Pull out the grooved pin.
C. Remove the shaft, spring and levers.
D. If necessary replace the governor bushi
ngs
(Fig. 76).
E. Install the shaft, spring and levers. Press fit the
expansion plug into the hole in the gear case.
Figure 74
9. Reverse steps 1 - 6 to reassemble the gear case. Use
new gaskets when assembling the gear case.
IMPORTANT: Install a new front oil seal before in-
stalling the gear case. Apply a thin coat of oil to the
circumference and lip of the oil seal.
Figure 75
Figure 76
Reelmaster
®
223-D/5100-D Page 3 - 55 Cylinder Block Overhaul
To Next Page
Loading...
