Toro Reelmaster 5100-D - Cutting Units will Not Lower

________________________________________________________________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
__
__ __ __ __ __ __
__ __ __ __ __ __
Cutting Units Will Not Lower
Cause Correction
S3, S4, or S5 not shifting (See Hydrauli
c Schemat-
ics to see which valve controls what lift cylinders.)
S6 not shifting.
S7 shifted (should only be shifted during lift
f
unction).
Do electrical diagnostics to make sure that voltage
i
s being applied to solenoid for affected circuit and
that there is no electrical fault. See Chapter 5 - Elec-
trical System.
Do cartridge valve service procedure for valve in af-
fect
ed circuit.
Interchange solenoid from affected circuit with an-
other similar valve (S3, S4, or S5) and check opera-
tion. Replace affected valve with a new valve if faulty.
Do electrical diagnostics to make sure that voltage
i
s being applied to S6 and that there is no electrical
fault. See Chapter 5 - Electrical System.
Do cartridge valve service procedure for valve S6.
R
eplace S6 with a new valve if faulty.
Do electrical diagnostics to make sure that voltage
i
s being applied to S7 and that there is no electrical
fault. See Chapter 5 - Electrical System.
Do cartridge valve service procedure for valve S7.
Troubleshooting Page 4 - 24 Reelmaster
®
5100-D