________________________________________________________________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
__
__ __ __ __ __ __
__ __ __ __ __ __
__ __ __ __ __ __
Condition Possible Cause Correction
Nothing happens when start Faulty ignition (key) s
witch or Test switch and replace if faulty.
attempt is made (control panel wiring. Correct wiring problem if
lights and gauges DO operate necessary.
with ignition key switch in ON
position). Traction neutral switch circuit open. Check traction control linkage
and adjust or repair.
Short circuit or open circuit Check wiring and repair if
between controller and start relay
. necessary.
Start relay faulty. Test relay and replace if
necessary.
Wiring between start relay and Check wiring and repair if
starter faulty. necessary.
Start solenoid faulty. Test start solenoid and replace if
necessary.
Engine starts, but dies when Run solenoid out of adjustment. Adjust run solenoid.
ignition key switch is released
from start position. Run solenoid faulty. Replace run solenoid.
Run solenoid wiring faulty
. Repair wiring.
Faulty high engine water Check switch and wiring and
temperature shut-down switch replace or repair if necessary.
(engine not
overheated) or wiring.
Starter c
ranks but engine will not Engine not cranking fast enough. Check battery and cable
start. connections. Charge battery.
Replace battery if it won’t accept
a charge. Repair wiring if
necessary.
Run solenoid out of adjustment Adjust run solenoid.
Faulty run solenoid. Replace run solenoid.
Problem is not electrical. See Troubleshooting sect
ion of
Chapter 3 - Engine.
Starter c
ranks, but should not Traction neutral switch circuit Check traction neutral switch
when traction pedal is depressed. closed. adjustment and adj
ust if faulty.
Test traction neutr
al switch and
replace if faulty.
Check traction neutral switch
wiring and repair if faulty.
Troubleshooting Page 5 - 10 Reelmaster
®
5100-D