Toro Reelmaster 5100-D - Page 170

________________________________________________________________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
________________________________________________________________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
__
__ __ __ __ __ __
__
__ __ __ __ __ __
Condition Possible Cause Correction
Engine kills when traction pedal Seat lifting off seat switch. Instruct operator to sit back in
is depressed. seat during operation.
Check seat plate hinges and seat
support pin and repair if faulty.
Seat switch circuit open. Test seat switch and replace if
faulty.
Check seat switch wiring and
repair if faulty.
Battery does not charge. Alternator belt slipping. Adjust belt tension.
Faulty wiring. Check and repair wiring.
Malfunctioning alternator. Repair or replace alternator.
Faulty battery
. Replace battery.
Cutting Unit Operation Problems
Condition Possible Cause Correction
Cutting units remain engaged, Seat switch circuit closed. Check seat plate hinges and seat
but shoul
d not, with no operator support pin and repair if faulty
.
on seat. Check for water soake
d seat
cushion.
Check seat switch and replace if
faulty.
Check seat switch circuit wiring
and repair if faulty.
Cutting units run, but shoul
d not, Front reels down sensor closed. Test f
ront reels down sensor and
when raised (but shut off with replace if faulty.
Enable/Disable switch).
Check front reels down sensor
wiring and repai
r if faulty.
Troubleshooting Page 5 -
12 Reelmaster
®
5100-D