7. Connect the tie rod end to the spindle bracket with 8. Install the lock nut and cap screw to secure the
one (1) nut. Tighten the nut to a torque of 25 - 33 ft-lb. steering cylinder rod end to the steering pivot. Tighten
Install the jam nut and tighten against the other nut to the nut to 130 to 150 ft-lb.
secure tie rod end.
9. Lubricate the bushings through the grease fitting on
t
he steering pivot.
3
6
5
4
1
12
2
11
10
8
13
7
9
Figure 16
1. Rear axle 6. Axle bushings 11. Washer
2. Steering cylinder 7. Steering pivot 12. Cylinder spacer
3. Lock nut 8. Tie rod 13. Steering pivot bushings
4. Rear axle pin 9. Wheel spindle
5. Washer 10. Snap ring
Reelmaster
®
223-D/5100-D/5300-D Page 7 - 13 Repairs
To Next Page
Loading...
