10. Reverse steps 1 - 5 to install the crankshaft (Fig. 97).
When installing the No. 1 and No. 4 bearing caps, apply
sealant (Permatex No. 2 or equivalent) to the upper
surface that meets with the cylinder block.
11. Use a dial indicator to measure the crankshaft end
p
lay. If end play exceeds specifications, replace all the
main bearings.
Crankshaft end play: 0.05 - 0.175 mm (0.002 - 0.007 in.)
12. Apply sealant (Permatex No. 2 or equivalent) to the
outside surface of the side seals. Install the side seals
with the radius towards the outside of the engine
(Fig. 96).
Figure 96
Figure 97
Reelmaster
®
223-D/5100-D Page 3 - 65 Cylinder Block Overhaul
To Next Page
Loading...
