i
l l i
i i li i il.
ll the fitti ll
l i
i i i
F.F.F.T.
±
±
±
±
±
±
i l
i
l l i
i i li i il.
j
i
ll i i i
il
i i i
i ion with a wrench
fl i
F.F.F.T.
±
±
±
±
±
±
SAE Straight Thread O-Ring Port (Non-adjustable)
1. Make sure both threads and sealing surfaces are free
of burrs, n cks, scratches, or any foreign material.
2. A ways rep ace the O-ring seal when th s type of fitting
shows signs of leakage.
3. Lubr cate the O-r ng with a ght coat ng of o
4. Insta ng into the port and tighten it down fu
ength until finger t ght (Fig. 4).
5. Tghten the f tting to the correct flats from finger t ght
(F.F.F.T.).
Size
4 (1/4 in. nominal hose or tubing) 1.00 .25
6 (3/8 in.) 1.50 .25
8 (1/2 in.) 1.50 .25
10 (5/8 in.) 1.50 .25
12 (3/4 in.) 1.50 .25
16 (1 in.) 1.50 .25
Figure 4
SAE Straight Thread O-Ring Port (Adjustable)
1. Make sure both threads and sealing surfaces are free
of burrs, n cks, scratches, or any foreign materia
(F g. 5).
2. A ways rep ace the O-ring seal when th s type of fitting
shows signs of leakage.
3. Lubr cate the O-r ng with a ght coat ng of o
4. Turn back the am nut as far as possible. Make sure
the back up washer s not loose and is pushed up as far
as possible (Step 1).
5. Insta the f tting into the port and t ghten f nger tight
unt the washer contacts the face of the port (Step 2).
6. To put the fittng n the desired position, unscrew t by
the required amount, but no more than one full turn
(Step 3).
7. Hold the f tting in the desired posit
and turn the jam nut with another wrench to the correct
ats from f nger tight (F.F.F.T.) (Step 4)
Size
4 (1/4 in. nominal hose or tubing) 1.00 .25
6 (3/8 in.) 1.50 .25
8 (1/2 in.) 1.50 .25
10 (5/8 in.) 1.50 .25
12 (3/4 in.) 1.50 .25
16 (1 in.) 1.50 .25
Figure 5
O-Ring
Step 1
Step 3
Step 4
Lock Nut
Back-Up Washer
O-Ring
Step 2
General Information Page 4 - 4 Reelmaster
®
5100-D
To Next Page
Loading...
