4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 67
4.5.21 2nd drawer detection switch (SW12)
(5) Remove the 1st drawer detection switch [2]
from the front side.
Fig. 4-181
(1) Remove the 1st drawer paper feed unit.
P. 4-58 "4.5.14 1st drawer paper feed
unit"
(2) Remove the 2nd drawer paper feed unit.
P. 4-61 "4.5.16 2nd drawer paper feed
unit"
(3) Remove the lower tray-up motor unit.
P. 4-68 "4.5.23 Lower tray-up motor unit"
(4) Disconnect 1 connector [1] from the rear
side, and then release 2 latches.
Fig. 4-182
(5) Remove the 2nd drawer detection switch [2]
from the front side.
Fig. 4-183
To Next Page
Loading...
