Toshiba E-STUDIO2508A - 6.5 Image Quality Adjustment (Printing Function); 6.5.1 Adjustment of smudged text in black

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 30
6.5 Image Quality Adjustment (Printing Function)
6.5.1 Adjustment of smudged text in black
The smudged/faint text can be set at the following codes.
< 05 Adjustment Mode >
<Procedure>
(1) Performs FS-05.
(2) Key in a code and press the [START] button.
(3) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(4) Press the [OK] button to store the value. The equipment goes back to the ready state.
(5) Turn the power OFF and then back ON to perform printing job.
(6) If the desired text density has not been attained, repeat step (2) to (5).
Language
Remarks
PS PCL XPS
7325 7326 7327 When a larger value is set, black text becomes thinner. When a smaller
value is set, it becomes thicker.
Acceptable values: 0 to 9 (Default: 5)