Toshiba E-STUDIO2508A - 4.7.14 Process unit fan (M2)

4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 99
4.7.14 Process unit fan (M2)
(3) Remove 2 screws and take off the toner
motor [2].
Notes:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
Fig. 4-265
(1) Remove the receiving tray.
 P. 4-2 "4.1.3 Receiving tray"
(2) Disconnect 1 connector on the duct [1].
Fig. 4-266
(3) Remove 1 screw and take off the duct [1].
Fig. 4-267