5
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SELF-DIAGNOSTIC MODE
5 - 45
(2) Press the icon to operate.
Remarks:
If the HDD type cannot be identified, "Unknown HDD" may appear on the screen.
P. 8-229 " [F106_1] ADI-HDD error: HDD type detection error"
Notes:
When "SATA HDD" (normal HDD) is displayed, items 1 and 2 are not selectable.
If you select any of 1 and 2 and press the [START] button, the error message “Operation Failed.
Press SoftPower Key to Switch Off.” appears.
5.14.3 Functions
[A] Revert factory initial status HDD
Select this to dispose of the ADI-HDD as well as the equipment.
When this item is selected, all data in the HDD are deleted and the HDD is reverted to its initial status at
the factory shipment.
The following screen is displayed when the [Revert Factory Initial Status HDD] icon is pressed.
Fig.5-30
Press [OK] to carry out the operation.
When the operation is finished, the result appears on the menu.
Notes:
If the equipment is started in the normal mode with this condition, an HDD mounting error occurs.
HDD Assist Mode (4C)
System Firmware Version: XXXXXXCurrent HDD Type :
Select Menu
Cancel
Revert
Factory Initial
Status HDD
Remove
Key
Confirmation Screen
Are you sure ???
Cancel OK
To Next Page
Loading...
