Toshiba E-STUDIO2508A - Page 767

8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 229
[F106_1] ADI-HDD error: HDD type detection error
[F106_2] ADI-HDD error: ADI encryption key download operation error
HDD • Connector check
• Harness check
• Perform the bad sector check (08-9072).
If the check result is OK, recover the data in the HDD. If
the check result fails, replace the HDD.
• If the error persists even after above step , replace the
HDD. If the equipment operation disabled after above
step , replace the HDD.
Classification Error item
Other service call
ADI-HDD error: HDD type detection fails.
Check Item Measure
Setting If the error is not recovered after rebooting the equipment
or no abnormality is found on any check items for the HDD,
reinstall the master data (HD Data).
HDD • Connector check
• Harness check
• Perform the bad sector check (08-9072).
If the check result is OK, recover the data in the HDD. If
the check result fails, replace the HDD.
• Check that either the ADI-HDD or SATA-HDD (normal
type) is mounted.
(1) Start the equipment in the 4C mode: [4] + [C] +
[POWER]
(2) Check the type of the HDD shown on the top left of
the control panel display “Current HDD type”.
Normal status: ADI-HDD or SATA-HDD
Abnormal status: Unknown HDD
If “Unknown HDD” is displayed, reinstall the master data
(HD Data).
• If the error persists even after above step , replace the
HDD. If the equipment operation disabled after above
step , replace the HDD.
Classification Error item
Other service call
ADI-HDD error: Downloading of or consistency check for ADI-
HDD encryption key fails.
Check Item Measure