Toshiba E-STUDIO2508A - TopAccess Administration - Software and Clone File Management

To Next Page

To Previous Page

OUTLINE OF THE MACHINE

3 - 30

3.8 Scanner

3.8.1 General Description

In the scanning section of this equipment, the surface of an original is irradiated with a direct light and

the reflected light is led through mirrors, a lens and a slit to CCD where optical-to-electrical conversion

is performed, converting the optical image data into an electrical (analog) signal. This analog signal is

changed to a digital signal, which then undertakes various corrective processes necessary for image

formation. After that, arithmetic operation is performed on the digital signal, which is then transmitted to

the data writing section.

In this equipment, a reduction-type CCD for color processing is used. What this CCD differs from black-

and-white CCDs is that its devices are arranged in 3 lines and covered with color filters (Red, Green,

and Blue). These lines are composed with 3-line color devices and black-and-white device with no filter.

Fig. 3-15

[1] ADF original glass

[2] Carriage-2

[3] Reflector

[4] Exposure lamp

[5] Carriage-1

[6] Original glass

[7] Drive pulley

[8] CCD board

[9] Lens

[10] Automatic original detection sensor

[11] Carriage home position sensor

[12] Platen sensor

[1]

[9]

[10]

[12]

[7]

[6]

[5][4][3][2]

[11]

[8]

Other manuals for Toshiba E-STUDIO2508A