Toshiba E-STUDIO2508A - 4.10.2 Front side cover; 4.10.3 Rear side cover; 4.10.4 Fuser roller cover

4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 123
4.10.2 Front side cover
4.10.3 Rear side cover
4.10.4 Fuser roller cover
(1) Remove the fuser unit.
 P. 4-121 "4.10.1 Fuser unit"
(2) Remove 2 screws and take off the front side
cover [1].
Fig. 4-331
(1) Remove the fuser unit.
 P. 4-121 "4.10.1 Fuser unit"
(2) Remove 2 screws and take off the rear side
cover [1].
Notes:
When installing the cover, put the harness
into the harness guide so that it will not be
pinched by the cover.
Fig. 4-332
(1) Remove the fuser unit.
 P. 4-121 "4.10.1 Fuser unit"
(2) Remove 2 screws, and take off the fuser
roller cover [1].
Fig. 4-333