Toshiba E-STUDIO2508A - 6.10 Adjustment of the Paper Feeding System; 6.10.1 Sheet sideways deviation caused by paper feeding

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 52
6.10 Adjustment of the Paper Feeding System
Adjust the laser writing start position in the primary scanning direction with the lower drawer. (FS-05-
4005, FS-05-4006)
If deviation still occurs, perform the following:
6.10.1 Sheet sideways deviation caused by paper feeding
<Procedure>
Bypass feeding
The center of the printed image shifts to the front
side.  Move the guide to the front side (Arrow
(A) direction in the lower figure).
The center of the printed image shifts to the rear
side.  Move the guide to the rear side (Arrow
(B) direction in the lower figure).
Fig.6-33
Fig.6-34
(1) Loosen the screw.
(2) Move the entire guide to the front or rear
side.
(3) Tighten the screw.
Fig.6-35
Feeding direction
Center
[Rear]
[Front]
Feeding direction
Center
[Rear]
[Front]
(A)
(B)