Toshiba E-STUDIO2508A - 4.12.3 ADU guide assembly <35 ppm;45 ppm;50 ppm>

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 152
4.12.3 ADU guide assembly <35ppm/45ppm/50ppm>
(5) Disconnect 1 connector and remove the
bypass feed clutch [5].
Notes:
When installing the bypass feed clutch,
attach the stopper [6] to the projection.
Fig. 4-408
Fig. 4-409
(1) Remove the transfer roller unit.
 P. 4-116 "4.9.3 Transfer roller unit"
(2) Remove the bypass feed clutch.
 P. 4-151 "4.12.2 Bypass feed clutch
(CLT2)"
(3) Remove 1 ground cable fixing screw.
Fig. 4-410