e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 192
4.13.10 MJ-6105 with MJ-1109 (Hole punch unit)
(14) Remove 2 screws. Lift up the hole punch unit
and take it off.
Fig. 4-525
(1) Press the [Power] button on the control panel
to shut it down.
(2) Turn the main power switch of the equipment
off.
(3) Disconnect the power cable.
(4) Remove the connector cover.
Fig. 4-526
(5) Disconnect the connector.
Fig. 4-527
To Next Page
Loading...
