Toshiba E-STUDIO2508A - 4.8.3 Filling developer unit with developer material; 4.8.4 EPU memory board (EPU)

4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 105
4.8.3 Filling developer unit with developer material
4.8.4 EPU memory board (EPU)
(1) Install the developer nozzle jig on the
developer bottle.
(2) Rotate the gear on the rear side of the
developer unit to the direction of the arrow
while filling the developer unit with the
developer material. Spread out the developer
material over the developer sleeve.
Fig. 4-283
(1) Remove the developer material.
( P. 4-104 "4.8.2 Removing developer
material")
(2) Place the developer unit upside down.
Disconnect 2 connectors.
Fig. 4-284
(3) Remove 1 screw. Then take off the EPU
memory board.
Fig. 4-285
Lid
EPU memory board
EPU memory board