Toshiba E-STUDIO2508A - 5.16 [76 SRAM Clear Mode]; 5.16.1 Overview; 5.16.2 Operation procedure

To Next Page

To Previous Page

SELF-DIAGNOSTIC MODE

5 - 52

5.16 [76 SRAM Clear Mode]

5.16.1 Overview

This is a mode in which you can clear particular errors such as F800 or F900 without entering a Service

Technician password.

When logging into [HS-73] fails due to a particular error, abnormality in the SYS-SRAM or its

replacement, the SRAM can be initialized with [Clear SRAM] in this mode.

The processing contents of this mode are the same as those for [Clear SRAM] in [HS-73].

Functions of 76 SRAM clear mode

• Sets the serial number of this equipment.

• Clears SRAM data when HS-73 cannot be used.

• Clears F800 error.

• Clears F900 error.

5.16.2 Operation procedure

(1) Perform [HS-76] by pressing the [76 SRAM Clear Mode] icon.

Then the following screen is displayed.

Fig.5-39

(2) Press the icon to operate.

Notes:

• The key board screen is displayed when pressing the icon.

Key in the serial number of this equipment and then press [OK] to determine the setting.

• Items 1 and 2 can be canceled while 0 and 3 cannot.

• When "3" is keyed in and the [START] button is pressed, the operation starts.

SRAM Clear Mode System Firmware Version

Update Mode

: xxxx(x.x.x.x)

: 6c Mode

0. Set Serial Number

1. Clear SRAM

2. Reset Date and Time

3. SRAM Re-Initialize Support

Other manuals for Toshiba E-STUDIO2508A