Toshiba E-STUDIO2508A - 4.7.10 Drum separation finger

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 96
4.7.10 Drum separation finger
(1) Take off the drum.
( P. 4-94 "4.7.8 Drum")
(2) Remove 1 screw of each unit to take off the
drum separation finger units [1] (3 pc.).
Notes:
1. When replacing the drum separation
fingers, make sure that the drum has
been taken off first since the fingers may
scratch the drum surface.
Fig. 4-257
(3) Remove the spring [2] and take off the drum
separation fingers [3].
Notes:
When the drum separation fingers have been
replaced, check if the pressure movement is
normal by moving them with your hands.
Fig. 4-258