4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 115
4.9.2 TRU fan (M9)
(1) Remove the transfer unit.
P. 4-114 "4.9 Transfer unit"
(2) Remove 4 screws and take off the inner duct
[1].
Fig. 4-314
(3) Disconnect 1 connector [2].
(4) Peel off the double-faced tape, and then
remove the TRU fan [3].
Fig. 4-315
Notes:
When installing, pass the harness [4] through
the harness guide as shown in the right
figure.
Fig. 4-316
To Next Page
Loading...
