4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 141
(4) Remove the lower exit roller [6].
Fig. 4-377
(5) Remove the idling roller [7] and 2 springs [8].
Fig. 4-378
Notes:
When replacing the the idling roller or idling
roller shaft, apply 0.5 x 2 rice-sized grain of
white grease (Molykote EM-30L) to each oil
groove [9] and [10].
Fig. 4-379
[9]
[10]
To Next Page
Loading...
