e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 66
Duplex copying:
(1) Shift the aligning plate with the scale as the guide shown in the figure below to adjust the skew.
Fig.6-68
(2) If the image skew is “C” as shown in the figure below, shift the aligning plate in the direction of
“-”, and if “D”, shift it to “+”.
Fig.6-69 Fig.6-70
Shift the aligning plate in the direction of “-”. Shift the aligning plate in the direction of “+”.
D
To Next Page
Loading...
