e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 96
[ 2 ] Folding position adjustment
(1) Turn OFF the power of the equipment.
(2) Remove 2 screws and take off the board access cover [1].
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Turn ON pin 1 and 4.
Fig.6-104
(4) Turn ON the power of the equipment while [FUNCTION CLEAR] button and [START] button are
pressed simultaneously.
(5) Press [Button 1] on the touch panel 10 times and then press [Button 2] once. Then press [Button
1] again 2 times, and [Button 2] once again. (Adjustment of LD and A3 paper starts.)
Fig.6-105
ON
1 2 3 4
[
1
]
LED3 LED2 LED1
Button2Button1
To Next Page
Loading...
