8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 11
E960 Offset tray jam Jam not reaching the offset tray transport sensor:
The paper has passed through the exit sensor does
not reach the offset tray transport sensor.
P. 8-114
E961 Stop jam at the offset tray transport sensor: The
trailing edge of the paper does not pass the offset
tray transport sensor.
P. 8-114
E9F0 Finisher jam
(Puncher unit)
Punching jam: An error occurs during the detecting
of the home position of the punch motor. This
occurs when an attempt is made to punch paper
which has been multiply fed from the equipment
and exceeds the punching capability. [MJ-1032/MJ-
1033]
P. 8-115
EA10 Finisher jam
(Finisher section)
Paper transport delay jam: The paper which has
passed the bridge unit does not reach the inlet
sensor.[MJ-1101/1107]
The paper which has passed the bridge unit does
not reach the inlet sensor. [MJ-1106/1108]
Paper transport delay jam: Paper does not reach
the entrance sensor of the Finisher. [MJ-1032]
P. 8-117
P. 8-117
P. 8-119
EA20 Paper transport stop jam:
The paper does not pass through the inlet sensor.
The paper which has passed through the inlet
sensor does not reach the feeding sensor.
[MJ-1101/1107/MJ-1106/1108]
Paper transport stop jam: Paper has reached the
entrance sensor but does not pass through it (paper
is remaining for a longer period than specified).
[MJ-1032/MJ-1033]
P. 8-118
P. 8-119
EA21 Paper size error jam: Paper does not reach the
sensor because the paper is shorter than spec.
[MJ-1101/1107/MJ-1106/1108]
P. 8-119
EA22 Paper transport jam (Finisher paper punching edge
detection sensor): The paper position sensor on the
Finisher transport path detects paper shorter than
the acceptable paper size. [MJ-1101/1107/MJ-1106/
1108]
P. 8-119
EA23 Finisher jam
(Finisher section)
Paper transport jam (transport sensor): Paper being
transported on the Finisher transport path is
stopped at the outlet sensor at 27.56 inches or
longer. [MJ-1101/1107/MJ-1106/1108]
P. 8-120
EA24 Paper transport jam (between entrance and
transport sensors): The leading edge of paper
which has passed the entrance sensor on the
Finisher transport path does not reach the transport
sensor. [MJ-1101/1107/MJ-1106/1108]
P. 8-120
EA25 Paper transport jam (after paper stack exit): The
finishing tray paper detection sensor detects paper
after a stack of paper exits from the finishing tray.
[MJ-1101/1107/MJ-1106/1108]
Paper transport jam in the Finisher (after paper
stack exit): Paper is detected in the finishing tray
sensor after the paper stack has exited from the
finishing tray. [MJ-1032]
Paper transport jam in the Finisher (after paper
stack exit): (1) Paper is detected in the finishing tray
sensor after the paper stack has exited from the
finishing tray. (2) Paper cannot be detected in the
gripper arm exit sensor after the paper stack has
exited from the finishing tray. [MJ-1033]
P. 8-120
Error code Classification Contents Troubleshooting
To Next Page
Loading...
