3
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
OUTLINE OF THE MACHINE
3 - 21
[ 3 ] Drawer feed copying (1st drawer paper feeding)
1. Press the [START] button
“READY” changes to “COPYING”
Exposure lamp ON
Scan motor ON carriages -1 and -2 move forward
Polygonal motor rotates in high speed
Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
2. Drawer paper feeding
Main charger, developer bias and discharge LED ON. Fans are rotated in high speed. Drawer
feed clutch ON.
- The pickup roller, feed roller and separation roller start to rotate.
Paper reaches the 1st transport sensor
- The 1st transport sensor is turned ON.
Paper reaches the registration roller.
- The registration sensor is turned ON and aligning is performed.
Drawer feed clutch OFF after a certain period of time
3. After the carriage operation:
Registration clutch ON after a certain period of time paper is transported to the transfer area.
Copy counter operates
4. After the registration clutch is turned ON:
Transfer charger ON after a certain period of time
Copy counter operates
5. Completion of scanning
Scan motor OFF
Exposure lamp OFF
Registration clutch OFF (after the trailing edge of the paper passed the registration roller)
“READY (PRINTING)” is displayed
“WAIT” is displayed
6. Paper exit
Exit sensor detects the trailing edge of the paper
Main charger, developer bias and discharge LED OFF
Polygonal motor, main motor and exit motor OFF
Drum, fuser unit and developer unit stop
Fans return to the ready rotation
“READY” is displayed and the equipment enters the ready mode
To Next Page
Loading...
