Toshiba E-STUDIO2508A - Page 779

8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 241
[F200] Data Overwrite option (GP-1070) disabled
[F500] HD partition damage
[F510] Application start error
Main memory • Check the installation
• Main memory check
Parts to be replaced Remark
Main memory
SYS board
Classification Contents
Other service call Data Overwrite option (GP-1070) disabled
Check Item Measure
Setting Perform firmware installation (all firmware: OS, HDD, SYS,
PFC Firmware, Engine Main Firmware, and Scanner
Firmware) with the USB media.
* When the function of the Data Overwrite option (GP-
1070) is deleted from the equipment, the service call
“F200” occurs.
Perform 08-3840 to install the Data Overwrite Enabler (GP-
1070).
* If F200 occurs while High (“3”) is set for the security
level (08-8911), it cannot be released by installing the
firmware using the USB media. Install the Data
Overwrite Enabler (GP-1070) by 08-3840.
Classification Error item
Other service call The file system is abnormal.
Check item Measures
Setting • Diagnose the file system with [5] + [C] + [Start]  1. Check
F/S, and then recover the problem partition with [5] + [C] +
[Start]  2. Recovery F/S.
• If it still is not recovered by performing the above, reinstall
the software after formatting the HDD with [3] + [C] +
[START] -> 3: Format HDD.
Classification Error item
Other service call The application fails to start.
Check item Measures
Setting 1. Reboot.
2. If it has still not recovered, reinstall the HDD software.
3. If it still persists after step 2, perform [3] + [C] + [Start] -> 3,
and then reinstall the HDD software.
Note: User data will be deleted when [3] + [C] + [Start] -> 3 is
performed.
Check Item Measure