Toshiba e-studio281c - Page 142

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
CONTROL PANEL
5 - 16
[B] Control panel unit
(1) Take off the right upper cover and the front
upper cover ( P.2-28 "[H] Right upper
cover",  P.2-27 "[G] Front upper cover").
(2) Disconnect 1 connector.
(3) Remove 2 screws and take off 2 harness
clamps.
Fig. 5-12
(4) Lower the control panel and remove 4
screws.
(5) Take off the control panel unit while sliding it.
Fig. 5-13
(6) Remove 3 screws and take off the cover.
Fig. 5-14
Control panel unit
Cover