Toshiba e-studio281c - Page 205

9
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
DRIVE SYSTEM
9 - 11
[B] Developer motor (M11)
[C] Black developer lifting clutch (CLT11)
(1) Take off the developer motor drive unit
( P.9-9 "[A] Developer motor drive unit").
(2) Remove 4 screws and take off the developer
motor.
Fig. 9-13
(1) Take off the developer motor ( P. 9 - 11 " [ B ]
Developer motor (M11)").
(2) Remove 5 screws and take off the bracket.
Fig. 9-14
(3) Disconnect 1 connector, remove 1 bushing
and 1 gear, and then take off the black devel-
oper lifting clutch.
Note:
Place the stopper when installing the clutch.
Fig. 9-15
Developer motor
Bracket
Connector
Bushing
Gear
Black developer lifting clutch