e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRIVE SYSTEM
9 - 12
[D] Color developer toner supply clutch (CLT8), color developer drive clutch (CLT9) and black devel-
oper drive clutch (CLT10)
(1) Take off the developer motor ( P. 9 - 11 " [ B ]
Developer motor (M11)").
(2) Release the harness from 3 harness clamps.
Fig. 9-16
(3) Remove 1 clip and1 bushing.
(4) Remove 4 screws and take off the bracket.
Fig. 9-17
(5) Disconnect 1 connector, remove 1 gear, 2
bushings and 1 clip, and then take off the
color developer toner supply clutch.
Note:
Place the stopper when installing the clutch.
Fig. 9-18
Bracket
Clip
Bushing
Gear
Bushing
Bushing
Clip
Connector
Color developer toner supply clutch
To Next Page
Loading...
