9
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
DRIVE SYSTEM
9 - 19
[G] Main motor drive unit
(1) Take off the process unit ( P. 11 - 1 0 " [ B ]
Process unit").
(2) Take off the rear cover-2 ( P.2-32 "[S] Rear
cover-2").
(3) Take off the LGC board case
( P.2-38 "[F] LGC board case").
(4) Take off the SYS board case
( P.2-35 "[D] SYS board case").
(5) Remove 3 screws and take off the flywheel.
(6) Take off the IH board case ( P.16-34 "[N]
IH board (IH) / IH board case").
(7) Take off the ozone exhaust fan with the
ozone exhaust duct ( P.11-24 "[R] Ozone
exhaust fan (M18)").
Note:
Steps (2) to (7) can be omitted if the devel-
oper motor drive unit and the transport motor
drive unit are already taken out.
(8) Disconnect 2 connectors and release the
harness from 2 harness clamps.
(9) Remove 6 screws and take off the main
motor drive unit.
Fig. 9-37
(10) Remove 3 screws and take off the drum
cleaner brush motor with the bracket.
Fig. 9-38
(11) Remove 2 screws and take off the drum
cleaner brush motor.
Fig. 9-39
Main motor
drive unit
Bracket
Drum cleaner brush motor
To Next Page
Loading...
